Home | Contact & Links | Customer Comments | Installation Instructions

LED Light Bars for Tour-Paks

RTFX146 LIGHT BAR
 

This video shows the RTFX146 cofigured with the two end segments as turn signals and operating through a TurnZ module for full "on" during brake and turn signal operation.  "Run" light is not used in this set-up.

 
  • 115 Super Bright LEDs that may be configured in three ways.
  • All LEDs can be used as a intensity bright auxiliary brake light
  • All LEDs can be used as a run + brake light
  • The center 65 LEDs can be used as a run + brake light while the end sections (25 LEDs can be used as turn signals)
  • Very low profile – 1/3 of an inch by 1/3 of an inch by 14.6 inches long
  • Fully assembled and ready to install
  • No cutting, breaking, or soldering
  • Sealed for protection from moisture and dirt
  • Includes dual intensity adapter and one packet of adhesion promoter
RTFX146 - Off
RTFX146 - on
RTFX146 LED Light Bar - $91.95
NOTE: The shipping cost as shown in the shopping cart is for US destinations only. International customers are required to request a shipping quote.
RT3M – 3M Adhesion Promoter Recommended for LED light Bars
RT3M – $1.89
NOTE: The shipping cost as shown in the shopping cart is for US destinations only. International customers are required to request a shipping quote.

©2007 - ridetimetechnology.com
Harley, Harley-Davidson, Tour-Pak, Electra Glide, Ultra, Ultra Classic, Classic, Road King, and other names or model numbers for Harley-Davidson motorcycles and products are registered trademarks of Harley-Davidson. Such names and designators are used for descriptive purposes only. Harley-Davidson does not make or endorse the use of Ride Time Technology products.